[Lithuania] Before introducing the Kyoritsu KEW 6305, we had problems with electrical measurements because we used old instruments with limited functions. We often needed several devices and setups to get the overall situation, which made troubleshooting slow, and sometimes unstable issues were missed and not caught. Measurement accuracy was not always consistent, especially with changes in load. Also, setup in different locations took too much time and slowed down our daily testing work.

[India] With our existing multimeters, we frequently experienced issues with erroneous readings, which reduced the reliability of electrical diagnostics during powertrain testing and sometimes even led to misleading conclusions. In addition, the manual range-selection knob required us to repeatedly switch between voltage ranges during testing, making the process slow and cumbersome, and significantly decreasing our overall efficiency.

[Spain] I previously required at least two or three different instruments to simultaneously perform power measurements, waveform visualization, and harmonics analysis.